& Restoration Line
A medium consistency asphalt base roof coating composed of refined asphalts, mineral stabilizer and solvent. Complies with CGSB 37-GP-8M.
As a spray or brush applied coating on asphalt built up roofs. Also used as a general purpose adhesive and repair material with asphalt saturated felts and approved glass cloths.
SOLIDS BY VOLUME: 80 % approx.
WEIGHT PER GALLON: 10 lbs. (approx.)
COVERAGE: 20 sq. ft. per gal. (with gravel, slag, sand) (approx.).
DRYING TIME: *****
TOUCH DRY: 4 hours (approx)
FIRM DRY: 48 hours (approx)
SERVICE TEMPERATURE: 95 C cured (upper limit)
APPLICATION TEMPERATURE: Ambient
FLAMMABILITY: Wet...Flammable Dry...Burns
Do not use in contact with Tar base products. Avoid use where solvent odours may taint food or other susceptible products. For ease of application during cold weather, condition product in warm temperature before use.
Surface must be free from moisture or frost. Remove all loose, cracked material, dust or dirt. On extremely dry or weathered roofing apply a brush coating of P.B.I. Roof Primer *Asphalt* at approx. 1/2 gal. per 100 sq. ft.. Avoid pooling and allow to dry for a minimum of 4 hours before application of the roof coating.
Apply by brush or spray equipment. Apply a coating to all lap seams and nail heads. Then uniformly coat the entire surface at the rate of coverage required. Allow the first coat to dry thoroughly, then apply the second at right angles to the first.
Use P.B.I. CLEAN-UP.
Up to 12 months in sealed container.
3.78 LTR. 20 LTR 205 LTR BULK - Tanker or Totes
Contains flammable solvents. Take suitable fire precautions. Do not allow smoking or welding in working area. Keep away from heat and open flame. Use in well ventilated areas. Keep containers covered when not in use.. Avoid prolonged breathing of the vapour and repeated contact with the skin. Harmful if swallowed.
All statements, technical information and recommendations for the use of this product are based on tests we believe to be reliable, but the accuracy or completeness is not guaranteed. In addition, design of application and conditions during and of installations are beyond the manufacturer's control. Before using, the user shall determine the suitability of the product for his intended use. The following is made in lieu of warranties expressed or implied: manufacturer's only obligation shall be to replace such quantity of the product that has proved to be defective. 11/99
© 2000 Protective Barriers Inc. All rights reserved